1. Philippines
  2. All 3M Products
  3. Electrical
  4. Splices & Accessories
  5. Cold Shrink Splices
  6. 3M™ Cold Shrink QS-III Splice Kit 5524A, Tape Shield, Wire Shield, UniShield®, 25/28 kV, 1 AWG-250 kcmil (50-120 mm2), 1/Case

3M™ Cold Shrink QS-III Splice Kit 5524A, Tape Shield, Wire Shield, UniShield®, 25/28 kV, 1 AWG-250 kcmil (50-120 mm2), 1/Case

  • 3M ID 7000006189
  • UPC 00051128539224

Inline splice for joining tape shield, wire shield, UniShield® or longitudinally corrugated shielded power cables

Special electrode design of the kit reduces the electrical stress at a critical cable/splice interface

Designed for inline splicing, feeder and distribution circuits, size transition splicing, direct burial installations and submerged locations

View more details
Frequently viewed resources
PDF (1) Copy 26Tech Data Sheet (PDF, 150KB)

Details

Highlights
  • Inline splice for joining tape shield, wire shield, UniShield® or longitudinally corrugated shielded power cables
  • Special electrode design of the kit reduces the electrical stress at a critical cable/splice interface
  • Designed for inline splicing, feeder and distribution circuits, size transition splicing, direct burial installations and submerged locations
  • Silicon rubber-splice body provides good high and low temperature performance, and the EPDM rubber jacket offers physical protection

3M™ Cold Shrink QS-III Inline Shielded Cable Splices 5524A, 5525A and 5526A Series are inline splices for joining 25/28 kV tape shield, wire shield, UniShield® or longitudinally corrugated (LC) shielded power cables. It is a cold shrink design.

The cold shrink splice body is a one-piece molded design made of specially formulated silicone rubbers, while the jacketing is made of EPDM rubber for its special physical properties. Each splice is high-voltage production tested to ensure reliability. Kits can be ordered with connectors packed in the kit, or the kit and connector can be ordered as separate items. Meets requirements of IEEE 404. Each kit makes one splice. Note: Cable sizes shown below are for standard insulation thickness. Final determining factor is cable insulation O.D.

Typical Properties

Resources

Manufacturing Origin: USA

The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S. Manufacturing plants. Some products contain imported components.

Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Contact customer service at 800-245-3573 to request a certificate.
For industrial/occupational use only. Not for consumer sale or use.

3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use.  Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice.  Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage.  For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.